HDMI 2.0 Extender over CATx

Send high-quality video & audio signals further, without replacing the copper cable, with this HDMI 2.0 Extender. In compliance with HDR & HDCP 2.2 standards, it supports 4K@60 4:4:4 resolution, Dolby & DTS HD audio, & bi-directional IR control, in a low-profile box. Configure the ARC channel feed for a TV (with ARC support) or an auxiliary S/PDIF input port via an audio output DIP switch on the receiver.

The extender uses proprietary one-way PoC technology to power the receiver from the transmitter. LEDs show power and signal status for established connections between devices.

With increased bandwidth up to 18-Gbps, you can extend signals over CATx cable up to 100 meters. while maintaining:

• Higher resolutions
• Higher frame rates
• Multiple full HD streams in the same pipe
• 21:9 aspect ratio

Approvals—: CE, FCC, IC, RCM, and VCCI
User Interface—: (1) 2 position switch (RX) to select between ARC or S/PDIF
LED Interface—: (1) Power LED, (1) Status LED, (1) HDCP LED, (1) Link LED
Leads Supported—: HDMI, IR, RS-232, 10/100/1000 Ethernet, S/PDIF
Connectors—: (1) 2.5mm barrel connector for power, (1) RJ-45 female for 10/100/1000 Ethernet, (1) RJ-45 female for CATx, (1) HDMI female, (1) 3-pin Phoenix for RS-232 serial extension, (2) 3.5mm IR Extension Port, (1) S/PDIF female
Input DDC Signal—: 5 V p-p
Input —:
Transmitter (1) HDMI female
Receiver: (1) CATx
Input Signal Type: —:
Transmitter: HDMI with 4K
Receiver: CATx
Input Video Level—: 0.5 – 1.0 V p-p
Maximum Pixel Clock—:
Transmitter: 594 MHz
Receiver: 584 MHz
Output—:
Transmitter (1) CATx
Receiver: (1) HDMI
Output Signal Type —:
Transmitter: CATx
Receiver: HDMI with 4K
Video Impedence—: 100 ohms
Power Consumption—: Transmitter and Receiver powered separately:
11.6 W (1080p)
18.96 W (4K @ 60 Hz YUV 4:4:4)
Operating Temperature—: 0ºC to 40ºC (32ºF to 104ºF)
Storage Temperature—: -20 to +70° C ( -4 to +158° F)
Operating Humidity—: 90% non-condensing
Dimensions—: 173W x 94.8D x 21H mm (6.81 W x 3.7 D x 0.83 H inches)
Weight—: 0,4 kg

(1) Transmitter
(1) Receiver
(1) Power adapter (12 VDC, 3 A)
(2) Phoenix male connectors (3.5-mm, 3-pin)
(1) IR emitter cable
(1) IR broadband receiver cable (30 kHz – 50 KHz)
(4) Mounting brackets